John Deere 3033R

Double tap to zoom



  • Powerful and reliable Yanmar Diesel Engine
  • AutoConnect™ deck compatible for deck attach/detach in seconds
  • Cab or Open Station configuration available
  • PowrReverser™ or E-hydro transmission with Twin Touch™ pedals


Manufacturer John Deere
Model 3033R (2017)
Family  EYDXL1.64NDA  
Manufacturer  Yanmar  
Engine model  3TNV88C-MJT  
Engine power (gross)  23.7 kW 
   32.2 hp 
Power take-off (PTO) power  Gear 4WD (four-wheel drive) - 18.5 kW 
   24.8 hp 
   Hydrostatic transmission (HST) 4WD - 18.1 kW 
   24.3 hp 
Rated engine speed  2600 rpm 
Type  Diesel  
Injection pump type  High pressure common rail direct injection  
Aspiration  Natural  
Emissions compliance  Final Tier 4  
Cylinders/displacement  3 / 1.64 L 
   3 / 100 cu in. 
Number of cylinders  Three  
Cylinder liners  Cast-in-block  
Bore and stroke  88x90 mm 
   3.46x3.54 in. 
Compression ratio  19.1:1  
Lubrication  Pressurized  
Cooling system  Water pump  
Air cleaner  Dual element with electronic restriction indicator  
Engine torque at rated speed  87 Nm 
   64.2 lb-ft 
Fuel tank capacity  Rollover protective structure (ROPS): 51.1 L 
   13.5 U.S. gal. 
   Cab: 44.7 L 
   11.8 U.S. gal. 
Battery size  500 CCA 
Alternator (12-V)  75 amp 
Starter size  1.4 kW 
   1.9 hp 
Fuel system  
Type  High pressure common rail direct injection  
Fuel consumption  7.6 L/hr 
   2.0 U.S. gal. 
*Fuel consumption rate should be used for comparison purposes only  ---  
Standard transmission; forward/reverse  Gear 4WD / eHydro (electronic hydrostatic)  
Optional transmission; forward/reverse  ---  
Left-hand reverser  Yes  
Transmission gear ranges  12F/12R PowrReverser (PRT)  
   3-range, infinitely variable  
Final drive  Bull Gear  
Brakes  Multi-plate wet disc  
Steering  Hydrostatic power steering  
Clutch, wet/dry  Wet disc  
Clutch disk diameter wet clutch  ---  
Axle capacity  ---  
Front  720-1450 kg 
   1587-3197 lb 
Rear  2400 kg 
   5292 lb 
Creeper  SpeedMatch optional  
Cruise control  Standard  
Differential lock  Yes  
Drawbar maximum vertical load    
Type  Open center  
Pump rated output  54.5 L/min 
   14.4 gpm 
Steering  22.3 L/min 
   5.9 gpm 
Implement  32.5 L/min 
   8.6 gpm 
Pump type  Dual gear  
Maximum operating pressure  172.4 bar 
   2500 psi 
Draft control sensing  Position control  
Remote control valves available  Up to four rear remotes  
3-point hitch  
Category  Category 1  
Lift capacity, 24-in. behind link arms  998 kg 
   2200 lb 
Power take-off (PTO)  
Standard  Independent Rear - 540 rpm  
Optional  Mid - 2100 rpm  
Control  Position control  
Clutch  Wet disc  
Brake (for mid and rear PTO)  Multi-plate wet disc  
Engagement method  Electro-hydraulic  
Fluid capacities  
Crankcase with filter  4.8 L 
   5.1 qt 
Transmission and hydraulic system  23.8 L 
   6.3 U.S. gal. 
Final drive  
Type  Bull Gear  
Differential lock  ---  
Operator station  
Rollover protective structure  ---  
Type  Foldable  
Platform - flat/straddle  Flat  
Gear shift location - console/floor  Left-hand side  
Compliance  Complies with OSHA, SAE, and CSA standards for roll-over protection  
Visibility  360 degree (angle) 
Air conditioning, temperature differential  ---  
Doors  Two  
Noise rating  80 dBA 
Seat equipment  ---  
Wheelbase  172.7 cm 
   68 in. 
Front axle clearance  31 cm 
   12.2 in. 
Turning radius with brakes  2.7 m 
   8.8 ft 
Turning radius without brakes  ---  
Limited slip differential  ---  
Approximate shipping weight (open-station; cab)  ROPS: 1315.4 kg 
   2900 lb 
   Cab: 1619.3 kg 
   3570 lb 
Front  Farm - 7-14  
   Turf (Gear 4WD) - 27x8.50-15  
   Turf (HST 4WD) - 25x10.5LLx15  
   R4 - 25x8.5-14  
Rear  Farm - 11.2-24  
   Turf (Gear 4WD) - 41x14-20  
   Turf (HST 4WD) - 41x18LL-16.1  
   R4 - 15-19.5  
Front tread range  114 cm 
   44.9 in. 
Rear tread spacing  103.1 cm 
   40.6 in. 
Toolbox  ---  
Tilt steering wheel  ---  
12-V Outlet  ---  
Date collected  ---