John Deere 830 Mid-Pivot MoCo

Double tap to zoom



  • Optional V10 rolls and Wide Swath Kit
  • Modular-design cutterbar
  • Adjustable roll pressure
  • Hydraulic tongue positioning


Model John Deere 830 Mower Conditioner
Power requirements  
PTO speed 540 or 1,000 rpm
HP 1000 rpm 1-3/8 in. PTO 70-150 hp (52-112 kW)
Powerline type Double-telescoping Grob spline (swivel is tube)
Hydraulic pressure required 2,000 psi (13,790 kPa)
Type John Deere
Cutting width 9.8 ft (3 m)
Cutting height 0.8-3.7 in. (2-9.5 cm)
Number of disks 6
Number of knives 12
Disk speed 2,650 rpm
Knife tip speed 191 mph (307 km/h)
Disk drive Gear
Lubrication Hy-Gard oil
Oil reservoir capacity 7.4 U.S. qt (7L)
Cutterbar oil check Combination check; Drain plug
Cutterbar angle Adjustable
Angle adjustment Mechanical Standard
Cutterbar protection Shearhub
Adjustable gauge shoes Yes
Width 73 in. (185 cm)
Diameter 23.5 in (60 cm)
Number of V-tines 45
Number of speeds Two
Drive 3-V powerband belt and sheaves
Conditioner hood Infinite adjust, single hand crank
Width 73 in. (185 cm)
Diameter 10 in. (254 mm)
Type of material Urethane
Design Recessed cleat
Speed 664 rpm
Drive Telescoping shaft
Tractor hookup  
Ball joint equal angle hitch Standard
Rockshaft swivel hitch Optional
Overall width  
Transport 9.8 ft (3 m)
Overall length  
Conventional transport 20.6 ft (6.3 m)
With urethane roll conditioner 5,553 lb (2,519 kg)
With impeller conditioner 5,238 lb (2,376 kg)
Standard tires 11L-15 standard
  31x13.5L 15 optional
Are wrenches required for adjusting?  
Roll pressure Yes
Roll spacing Yes
Hea+A34:B56der Tilt Yes